Aastra 6753i 6753i User Guide, SP3, HF1 - Page 163

Additional Features Preferred Line and Preferred Line Timeout The 6753i has a feature called "preferred line" and "preferred line timeout". If you enable the preferred line parameter on your phone, after a call ends (incoming or outgoing), the display switches back to the preferred line. Next time you go offhook to make another call, you pickup on the preferred line. You can enable the preferred line parameter using the Aastra Web UI at the location, Basic Settings->Preferences->General. You can also set a preferred timeout parameter that specifies the number of seconds it takes for the phone to switch back to the preferred line. Note: You can configure "Preferred Line" and "Preferred Line Timeout" using the Aastra Web UI only. The following table provides the behavior of the preferred line focus feature with other features on the phone. Phone Feature call return speed dial conference transfer blf park voicemail redial dialing caller id factory default Preferred Line Behavior The phone switches back to the focused line immediately after the call ends. The line is already specified when the speed dial is created. The phone switches back immediately after the call ends. For incoming calls, the phone switches back immediately after the call ends. For incoming or outgoing calls, the current behavior is that the same line used to transfer the call does not change. For incoming calls, the phone switches back immediately after the call transfers. The phone switches back immediately after the call ends. The phone switches back immediately after the call ends. The phone switches back immediately after the call ends. The phone switches back immediately after the call ends. For incomplete dialing on a non-preferred line, the focus does not change if some digits are entered. If no digits are entered or digits were cleared, the focus changes to preferred line after the time out has passed without activities. If the "Switch UI Focus To Ringing Line" parameter is disabled, the User is able to see the Caller ID when the phone switches the focus to the ringing line. Factory default and recovery mode clears the "preferred line" and "preferred line timeout" parameters, and the phone operates in a non-preferred line mode. Notes: 1. If you specify a value of "0" for the preferred line parameter, it disables the preferred line focus feature. 2. If you specify a value of "0" for the preferred line timeout parameter, the phone returns the line to the preferred line immediately. 41-001380-00 REV01 - 06.2013 156