Adaptec 5325302057 User Guide - Page 43

Step 2: Configuring the iSCSI Storage Appliance 2 Under Network settings, enter the values you prepared in "Before You Begin" on page 34. Enter a name for the iSCSI Storage Appliance and the network domain to which the iSCSI Storage Appliance belongs. Enter a gateway name or IP address, or accept the default gateway. Enter IP addresses for up to three domain name servers, if required. 3 (Optional) Under CLI settings, change the Administrator and Operator passwords from their defaults. (By default, both passwords are 'admin'.) 4 Click Next, then set values for each Ethernet port on your iSCSI Storage Appliance, using the tabs at the top of the window to ensure that all ports are configured. Use static IP addresses for each port, and ensure that DHCP is deselected. Click tabs to view other ports Deselect DHCP Note By default, Ethernet Port 0 is the management port and is used by the Management Service to communicate with your iSCSI Storage Appliances; it is also an iSCSI port. You can configure Ethernet Port 0 as a management port only by selecting that option in the Port Type drop-down menu. 5 Click Next. By default, the current date and time is used for the iSCSI Storage Appliance. You can choose to manually set the date and time values, if required. Note The Adaptec OnTarget operating system does not automatically adjust the time setting on your iSCSI Storage Appliance to accommodate Daylight Saving Time. However, the appliance uses the time setting for event timestamps only; the appliance time setting is not used for job schedules or other functions. 6 Click Next, confirm the settings for this iSCSI Storage Appliance, then click Apply. Chapter 4 Setting Up Your iSCSI Storage Appliance and IP SAN 37