Alcatel OS6850-P48 User Guide - Page 146
Installing DC Power Source Wire Leads, Opening Connector for Ground Wire, Warning.
View all Alcatel OS6850-P48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
OmniSwitch 6850/6850E Series Power Supplies OmniSwitch 6850/6850E Series Power Supplies A clamp inside each slot keeps the power wire tightly in place during operation. The DC power supply has side screws that can be used to remove the connector if required. Installing DC Power Source Wire Leads These instructions describe how to connect your 3-wire DC power source to the power connector on your DC power supply. A small flat-tip screwdriver and a wire stripper are required for this procedure. 1 Prepare the three (3) wires-12 gauge-that will plug into the power supply. First make sure they are not plugged into the DC power source. Next, use a wire stripper to carefully strip between .24 and .30 inches (6-7.5 mm) off the end of each wire, removing the outer insulation to expose the copper core. 2 Open the clamp for the ground wire slot by inserting a small flat-tip screwdriver into the top of the appropriate circular hole. Loosen the screw so that the clamp for the ground wire opens. Loosen Screw. + - Clamp inside square hole will open when screw is loosened in top circular hole. Opening Connector for Ground Wire 3 Insert the ground wire lead into the slot. The lead you insert must match the lead attached to the DC power source. Warning. You must plug DC wire leads into the correct holes in the DC power connector. Use the labels above the DC power connector as a guide to positive, negative, and ground connections. If the wire leads are plugged into the wrong holes, the power supply will not work properly and damage to the unit may result. Push the wire in far enough such that it reaches the back wall of the connector, about a half inch inside. + - page 4-18 Ground Wire Attaching the Ground Wire OmniSwitch 6850/6850E Series Hardware Users Guide June 2011