Alcatel OS6850-P48 User Guide - Page 81
Installing and Removing Combo Port SFPs, Attaching the Switch to the Rack, Note.
View all Alcatel OS6850-P48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
OmniSwitch 6850 Series Chassis and Hardware Components Mounting the Switch 3 After the rack-mount flanges are secured to the chassis, mark the holes on the rack where the switch is to be installed. 4 Lift and position the switch until the rack-mount flanges are flush with the rack post. 5 Align the holes in the flanges with the rack holes that were marked in step 3. 6 Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each flange. Tighten both screws until they are secure. Attaching the Switch to the Rack Note. Be sure to install the screws in the bottom hole of each flange, as shown, before proceeding. 7 Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws. Be sure that all screws are securely tightened. Note. If you are installing multiple switches in a rack to form a stacked configuration, refer to "Setting Up a Stacked Configuration" on page 2-62. Installing and Removing Combo Port SFPs OmniSwitch 6850 Series switches offer four Gigabit Ethernet combo ports, located on the front panel (see page 2-22). These combo ports support hot-swappable fiber Small Form-Factor Pluggables (SFPs). For instructions on installing and removing combo connector SFPs, refer to the OmniSwitch Transceivers Guide. OmniSwitch 6850/6850E Series Hardware Users Guide June 2011 page 2-61