Apple Macbook Pro Aluminum 13-Inch Black Laptop Keyb Technical Guide - Page 30
Test and inspect Top Case, With DVM, verify
UPC - 005215163007
View all Apple Macbook Pro Aluminum 13-Inch Black Laptop Keyb manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
2010-06-15 7. Inspect MagSafe port on Yes computer for physical damage, debris or metal fragments No attracted to magnetic connector. Is MagSafe connector clean and free from defects? 8. Verify adapter status LED Yes turns on green then orange indicating power and battery charge in progress. A green LED can indicate a full battery, removal of battery or battery not recognized. No 9. Verify power from adapter is Yes present on logic board. Remove system battery, use AC power only. With DVM, verify voltage presence of Q7001, pin 5 is 16.7Vdc with AC adapter connected. Reseat or test known-good MagSafe cable to achieve power for logic board. No 10. Test and inspect Top Case Yes Power Button. Stuck or open power on key or keyboard disconnect can disable the power on of system. If button does not work, locate R5015 pads on logic board just above trackpad connector, and short pads to power up logic board. If power on key is stuck, keyboard cable must be disconnected for R5015 to No work. Does system power on? (Reconnect keyboard cable to confirm bad or intermittent connections.) Go to step 8 Clean port assembly. Replace X03 MagSafe board if necessary. System starts and has power. MagSafe LED indicates power is flowing to logic board. Verify customer battery will also charge. Review battery P11 health to ensure customer satisfaction. AC power is down or battery is not charging. Go to step 9 Logic board has power X03 adapter energy to start system, 16.7V found on Q7001. MagSafe cable reseat or replacement resolved issue. If still no system power on indications, go to step 10 No voltage measured on Q7001, AC adapter power not M21 going to logic board power supplies. Replace logic board. Power on key works fine, issue resolved. Power on key works when keyboard cable is reseated. Power on key appears to K05 be stuck, had to remove keyboard cable for R5015 power on. Replace top case for stuck power on key No logic board power on M01 when shorting R5015 pads. Replace logic board. MacBook (13-inch, Aluminum, Late 2008) Symptom Charts - Startup and Power Issues 30