Asus M4N98TD EVO User Manual - Page 44
Internal connectors
View all Asus M4N98TD EVO manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
2.8.3 Internal connectors 1. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There are three connectors on each Ultra DMA 133/100 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Chapter 2 Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) Cable connector - Black Master Black Slave Gray Master Black or gray Slave • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100 IDE devices. If any device jumper is set as "Cable-Select", ensure that all other device jumpers have the same setting. 2-26 Chapter 2: Hardware information