Home » BenQ Manuals » Wireless » BenQ WDC20 » Manual Viewer

BenQ WDC20 User Manual - Page 16

Positioning the Host antennas, For ceiling installation

Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Positioning the Host antennas Once you have properly installed the Host, follow the guidelines below to position the antennas to maximize signal reception: For ceiling installation Position the antennas so that they are both pointed downwards at an angle roughly perpendicular to the ceiling: For ceiling mount installation • Position the antennas so that they are both point either upwards or downwards roughly parallel to the ceiling mount: • If you encounter bad signal reception after initial use of the Host you can manually adjust the antennas so that they tilt at a slight angle to maximize signal reception. When doing so, avoid tilting the antennas toward the ceiling mount: 16 Installation

Section	Page
Copyright	2
Disclaimer	2
BenQ ecoFACTS	2
Introduction	5
Product features	6
Package content	7
Product specification	8
Overview	9
Button	9
Host	9
LED indicators of the Button and the Host	10
Installation	11
Environment check	11
Assembling the Host	12
Setting up the Host	12
Attaching the Host to the ceiling	12
Attaching the Host to a ceiling mount	13
Placing the Host on a table	13
Installing the Host on the wall or trolley	15
Positioning the Host antennas	16
For ceiling installation	16
For ceiling mount installation	16
For table placement	17
Connecting the HDMI cable and power	17
Assembling the adapter	18
Connecting the HDMI cable	19
Power supply via a power adapter	19
LAN connection	20
Setting up and powering a Button	20
Using Cable USB A(F) to USB A(M)	23
Pairing a Button and Host	24
When the Host is placed on a table	24
Storing Buttons and USB cable in the cradle	26
Resetting a Host	26
Resetting a Button	27
Enabling network standby mode	28
Starting and stopping presentations	29
Getting ready	29
Starting presentation	29
Idle presentation	30
Split screen presentations	31
Starting a split screen presentation	31
Switching from a split screen to a full screen presentation	32
Presenting with mobile devices	32
Touch back	34
Web management	35
Accessing the web management interface	35
Logging into the web management interface via direct connection	35
Logging into the web management interface via LAN	37
Logging into the web management interface via a wireless network	37
Getting started	39
Top command buttons	39
Change language	39
Logging out	39
Function bar	39
Main column	40
Information	40
WAN	42
Wireless Network	43
Setting	43
Wi-Fi Radio Setup	45
Wireless Nodes Status	48
Pairing	49
Advance Setting	51
Scheduling	56
Tool	57
Password Setup	57
Firmware Upgrade	58
Configuration Management	62
Wi-Fi Traffic Test	63
Log Setting	66
Legal Announcement	66

Match case Limit results 1 per page

Installation

Positioning the Host antennas

Once you have properly installed the Host, follow the guidelines below to position the antennas to

maximize signal reception:

For ceiling installation

Position the antennas so that they are both pointed downwards at an angle roughly perpendicular to

the ceiling:

For ceiling mount installation

• Position the antennas so that they are both point either upwards or downwards roughly parallel to

the ceiling mount:

• If you encounter bad signal reception after initial use of the Host you can manually adjust the

antennas so that they tilt at a slight angle to maximize signal reception. When doing so, avoid tilting

the antennas toward the ceiling mount: