Binatone iDECT C10i User Manual - Page 33

7.9 Set the recall time You may need the R button to send a Recall signal (also called Flash or Timed Break Recall) for network services or if you are connected to a PBX. You should normally leave the Recall Time at its default setting of Short (100ms), as this is the standard recall required in the UK telephone network, but it can be changed to Medium (250ms) or Long (600ms) if your telephone is connected to a PBX that requires a different recall time. 1. Press . 2. Press to select ADV SETTING and then press . 3. Press to select RECALL TIME and then press . 4. Press to select SHORT, MEDIUM or LONG and then press to confirm the setting. 7.10 Set the first ring When this function is set to Off, the first ring from an incoming call will not sound. This is useful on exchanges where calling line identity is sent after the first ring. 1. Press . 2. Press to select ADV SETTING and then press . 3. Press to select FIRST RING and then press . 4. Press to select ON or OFF and then press to confirm the setting. 7.11 Set the dial mode You should normally leave the dialling mode at its default setting of TONE (also called DTMF) unless the phone is connected to an old exchange that only recognises PULSE dialling. NOTE: If PULSE dialling is set, during a call you can press < * > to switch to TONE dialling for the rest of that call. 1. Press . 2. Press to select ADV SETTING and then press . 3. Press to select DIAL MODE and then press . 4. Press to select TONE or PULSE and then press to confirm the setting. 31