Bowflex Ultimate 2 Assembly Manual - Page 19
Step 2 - screws
View all Bowflex Ultimate 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
18 Assembling Your Bowflex Ultimate® 2 STEP 2 Parts: • Handle and Base Assembly (from Step 1) • Plastic Handle Top and Bottom • Cable Retainer Pins (Hardware Card) • Plastic Plug Covers Tools: • Hex Key (5/32") Front Handle Plastic Plug Cover (N) Plastic Plug Cover (H) 2-1 Lay the Handle and Base Assembly down on the floor, remove the Plastic Plug Covers and separate the Top and Bottom of the Plastic Handle. Plastic Handle Top Cap Screw 2-2 Remove the Twist Ties. 2-3 Feed cables through Metal Handle and position the Cable End Loop just inside the Hollow Tube. You may have to slide the Hollow Tube toward the Front Base to allow cables to reach. Hollow Tube Cable Retainer Pin 2-4 Insert Cable Retainer Pins through hole and cable loop. (See Detail A) 2-5 Position Top and Bottom of Plastic Handle. Plastic Plug Cover (H) Plastic Handle Bottom Nut #10 NOTE: T he hexagonal holes in the left side of the Handle are shallower than the holes in the right side. The #10 Nuts go in the deeper hexagonal holes on the right side of the handle. The right side can be identified by noting a small hole in the plastic flange. (See Detail B) 2-6 Install and completely tighten the hardware. Plastic Plug Cover (N) Cable Retainer Pin through hole and Cable End Loop 2-7 Install Plastic Plug Covers over hardware. NOTE: The Plug Covers are marked on the inside with an "N" or an "H". To insure proper fit, use the caps marked with an "N" to cover the nuts and the caps marked with an "H" to cover the screw heads. Detail A Note small hole in Handle on Right side Hardware (1:1): 2 Cap Screws (#10 X 1") 2 Nut (#10) 2 5.27 Cable Retainer Pins Deeper Hole Detail B