Bowflex Ultimate 2 Assembly Manual - Page 24

23 Assembling Your Bowflex Ultimate® 2 After installing the Rod Box in Step 7, install the Rod Retainer. STEP 7B Parts: • 1 Rod Box Retainer Tool: • Phillips Head Screw Driver Note: Rod Box screws must be installed before proceeding. 7B-1 Remove both screws connecting the backing plate and the face plate (See Figure A). 7B-2 Stand facing the rear of the Bowflex Ultimate® 2 unit. Place the backing plate (larger piece), with the curved side facing up, in between the two right-side 50 lb. rods (See Figure B). Verify that the notched lip of the backing plate is located in the slot of the Box Frame. 7B-3 Match up the face plate (thinner piece) to the backing plate on the outside of the rod box. Make sure that the notched lip of both backing plates are touching and that the holes are aligned. 7B-4 Fasten both screws into the lined up holes (See Figure C). Tighten until snug and then another quarter turn. Unscrew Figure A Backing Plate Rod Box Figure B Insert into slot of Rod Box Frame Face Plate Rod Box Retainer (screws are pre-installed) Notched Lip Figure C Face Place Backing Plate Qty: 2 Self Threading Screws (#10 x 1") Curved Side