Bowflex Ultimate 2 Assembly Manual - Page 20

19 Assembling Your Bowflex Ultimate® 2 STEP 3 - Use two people for this step! Parts: • Front Base Assembly • Rear Base Platform (Box 2) Tool: • Hex Key (7/32") • Wrench (9/16") - or Adjustable Wrench 3-1 Remove Wire Ties from Bushings. 3-2 Slide Front Base toward rear base until the Locking Pins make contact with the side plates. MAKE SURE the Flanges slide over the Bushings during this procedure. (See Top Detail View)  3-3 Squeeze the Front Handle to retract the Locking Pins, lift the handle about 3-4 inches and push Front Base completely into the Rear Base Release the handle and make sure the Locking Pins protrude through the Side Plates. 3-4 Insert the Button Head Bolt and Washer then squeeze Front Handle and fold Front Base up to install Inside Washer and Hex nut. Completely tighten hardware. Remove Wire Ties A from Bushings Bushings Rear Base Platform Locking Pin TOP DETAIL VIEW B Make sure Flanges slide over Bushings Slide Front Base towards Back Base Until it Contacts Pins Side Plate Side Plate C Pan Head Allen Bolt D Squeeze Handle and Fold Front Base up to install Nylock Nut and Washer Locking Pin TOP DETAIL VIEW Washer Hardware (1:1): Washer Nylock Nut 2 Pan Head Allen Bolt (3/8" X 3") 4 Washers (3/8") 2 Nylock Nut (3/8")