Bowflex Ultimate 2 Assembly Manual - Page 36

35 Installing Your Bowflex Ultimate® 2 Cables Cable Installation STEP 1 Tool: • Hex Key (7/32") • Wrench (9/16") - or Adjustable Wrench a. Uncoil cable from Upper Pulley Slider. b. R emove Ball Stop from the end of cable that is to be routed through pulleys by sliding the outer ball back from the cable end and pushing out the slotted insert. Slide the ball off of the cable and set aside. (See Figure A) c. Remove the pulley from the Upper Pulley Bracket, wrap the cable over the pulley (See Figure B) and reinsert the pulley back into the Upper Pulley Bracket. Make sure the cable is inside the Side Plate before moving on to STEP 2. (See Figure C) Slide Ball Back Cable End Remove Slotted Insert Figure A Remove Pulley from Upper Pulley Bracket Cable Routed Inside Side Plate Pulley Route Cable Over Pulley Figure B Replace Pulley and Hardware with Cable Figure C