Bowflex Ultimate 2 Assembly Manual - Page 21

20 Assembling Your Bowflex Ultimate® 2 The cables that retract the locking pins may stretch with use. If the locking pins do not fully retract or interfere with the side plates, make the following adjustment. Cable Adjustment (Requires Two People) 1. Position the base somewhere between the two locking positions. 2. Pull the handle until it is in the most compressed position. 3. Place a 1/4" or adjustable wrench on the Adjusting Barrel and use a 1/4" or adjustable wrench to loosen the locking nut. (See Detail B) 4. Rotate the Adjusting Barrel clockwise to increase the cable tension. The Locking Pins should be as close to the Side Plates as possible without making contact. (See Detail A) 5. Test the adjustment by releasing the handle and rotating the base to a locking hole. Make sure pin securely engages with the locking hole then pull the handle and make sure the unit moves freely. 6. Repeat the procedure for both sides if necessary. 7. Tighten Lock Nuts against Adjusting Barrel. Make sure Locking Pin is as close as possible without making contact with Side Plate Pull handle and position base between the locking positions. Adjusting Barrel Locking Nut Detail A Detail B