Brother International MFC 3220C Users Manual - English - Page 89

Dual Access (Not available for color faxes) You can dial a number, and begin scanning the fax into memory- even when the machine is sending from memory or receiving faxes. The LCD shows the new job number and available memory. Your machine normally uses Dual Access. However, to send a color fax, the machine will send the original in real time (even if Real Time TX is Off). The number of pages you can scan into the memory will vary depending on the data that is printed on them. If you get a Out of Memory message while scanning the first page of a fax, press Stop/Exit to cancel scanning. If you get a Out of Memory message while scanning a subsequent page, you can press Black Start to send the pages scanned so far, or press Stop/Exit to cancel the operation. Real Time Transmission When you are sending a fax, the machine will scan the originals into the memory before sending. Then, as soon as the phone line is free, the machine will start dialing and sending. If the memory becomes full, the machine will send the original in real time (even if Real Time TX is set to Off). Sometimes, you may want to send an important original immediately, without waiting for memory transmission. You can set Real Time TX to On for all documents or for the next fax only. If you want to fax multiple pages, use Dual Access. (See Dual Access (Not available for color faxes) on page 6-10.) 1 If it is not illuminated in green, press (Fax). 2 Load your original. (See Load originals on page 2-1.) 3 Press Menu/Set, 2, 2, 5. 5.Real Time TX SETUP SEND 6 - 10