Brother International PT-9600 Service Manual - Page 109
the RS I/F Port Check Mode as shown in Fig.53.
UPC - 012502602774
View all Brother International PT-9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
(4) Press the "RET" key. The machine writes the entered correction value described above into the EEPROM and displays as shown in Fig.52. Fig. 52 (5) Press the "RET" key while the LCD displays as shown in Fig.52. The display shifts to the RS I/F Port Check Mode as shown in Fig.53. Note: Press the "9" key before shifting to the Margin Set Mode. The display shifts to the Avery Print Mode. Check again the start position of printing area of the sample print. 2.16. Margin Set Mode ( " R " key ) This mode adjusts the margin cut length. Note 1: You may skip this mode if the print sample by the Print Mode 1 gets into the specified zone. Fig. 53 (1) Press the "RET" key. The display shifts to one as shown in Fig.54. Fig. 54 (2) Press the "1" key and set the number of counter rotation pulses at the margin cut process (10 through 150 pulses). Note 2: The number of counter rotation pulses is the number of counter rotation pulses after the print operation. (3) Press the "2" key and set the number of superimposed dots at the margin cut process (0 through 3 dots). Note 3: The number of superimposed dots is the number of the superimposed dots required at the normal rotation after the counter rotation. (4) Press the "3" key and set the number of offset pulses at the margin cut process (-4 through +4 pulses). Note 4: The number of offset pulses is the number of offset pulses to adjust the print start position at the margin cut process. III-75