Brother International PT-9600 Service Manual - Page 71
Fig. 3.2-13, Reassembling the Head/Roller Holder Unit 2, Fig. 3.2-14, Reassembling the Head/Roller
UPC - 012502602774
View all Brother International PT-9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
(2) Fit the roller holder release spring over the bottom end of the roller holder ASSY, with one end of the roller holder release spring inserted into the groove in the roller holder. Insert the upper and end of the platen shaft into the hole of the head ASSY while slightly tilting the roller holder ASSY. (3) Attach the roller holder ASSY to the head ASSY, with the bottom end of the platen shaft being inserted in the slit in the head ASSY. Note 1: The roller release spring must be caught in the correct portion of the head ASSY. Note 2: Apply the silicon grease (Shin-Etsu Chemical brand G501) by a quarter rice-grain sized drop with a brush on each end of platen shaft. Note 3: Pass the AV sensor harness over the roller holder release spring as indicating in "A" shown below, when assembling the roller holder ASSY to the head ASSY. AV sensor PCB Head ASSY Apply grease. Roller holder ASSY Platen roller Roller holder release spring "A" Roller holder release spring Head ASSY Apply grease. Fig. 3.2-13 Reassembling the Head/Roller Holder Unit (2) (4) Insert the roller holder shaft from the bottom of the head ASSY, then secure the shadt using the retaining ring. Note: Press the back of the roller holder ASSY to check its smooth rotation. Retaining ring Head ASSY Roller holder shaft Fig. 3.2-14 Reassembling the Head/Roller Holder Unit (3) III-37