Brother International PT-9600 Service Manual - Page 78
Installing the Head/Roller Holder Unit
UPC - 012502602774
View all Brother International PT-9600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Installing the Head/Roller Holder Unit (1) Pass the thermal head harness and the AV sensor harness through the slots, shown in figure below, of the chassis ASSY. (2) Assemble the head/roller holder unit on the chassis ASSY with two screws. Note: Apply the silicon grease (Shin-Etsu Chemical brand G501) by a half rice-grain sized drop when assembling to the main frame. (3) Move the release lever to check for the correct operation of the head/roller holder unit. Screws AV sensor harness (PT-9600/PT-3600 U.S.A. only) Head/roller holder unit Chassis ASSY Thermal head harness Apply grease. Fig. 3.2-26 Installing the Head/Roller Holder Unit III-44
III-44
Installing the Head/Roller Holder Unit
(1)
Pass the thermal head harness and the AV sensor harness through the slots, shown in figure
below, of the chassis ASSY.
(2)
Assemble the head/roller holder unit on the chassis ASSY with two screws.
Note: Apply the silicon grease (Shin-Etsu Chemical brand G501) by a half rice-grain sized
drop when assembling to the main frame.
(3)
Move the release lever to check for the correct operation of the head/roller holder unit.
Fig. 3.2-26
Installing the Head/Roller Holder Unit
Apply grease.
Head/roller
holder unit
Thermal head harness
AV sensor harness
(PT-9600/PT-3600 U.S.A. only)
Chassis ASSY
Screws