Brother International SE725 Operation Manual - Page 48

Utility Stitches Unfold the edge of fabric, and position the fabric with e the wrong side facing up. a c f b d a af a ac a e b 1 Wrong side of fabric 2 Right side of fabric 3 Edge of fabric 4 Desired edge of hem 5 Basting point 6 Basting Attach blind stitch foot "R". f Adjust the stitch width until the needle slightly catches k the fold of the hem. (page 35) 1 Needle drop point When you change the needle drop point, raise the needle, and then change the stitch width. * To make fine adjustments to the needle drop point, adjust the stitch width setting. (The stitch width setting is in neither millimeters nor inches.) 1 Thick fabric 2 Normal fabric a b Select a stitch. g No. Stitch 2-01 2-02 • For details, refer to "Stitch Chart" on page 41. Remove the flat bed attachment to use the free arm. h Slide the item that you wish to sew onto the free arm, i make sure that the fabric feeds correctly, and then start sewing. 1 Free arm a Memo • Blind hem stitches cannot be sewn if the left needle drop point does not catch the fold. If the needle catches too much of the fold, the fabric cannot be unfolded and the seam appearing on the right side of the fabric will be very large, leaving an unattractive finish. Sew with the fold of the hem against the presser foot l guide. Press the "Start/Stop" button to stop sewing when you m are finished, and raise the presser foot and needle to pull the fabric under the presser foot towards the back of the machine. Position the fabric with the edge of the folded hem j against the guide of the presser foot, and then lower the presser foot lever. 1 Wrong side of fabric 2 Fold of hem 3 Guide IMPORTANT • Be sure to pull the fabric towards the back of the machine after sewing. If you pull the fabric toward side or forward, the presser foot may be damaged. Remove the basting stitching and turn the fabric with n the right side facing out. 1 Wrong side of fabric 2 Right side of 1 2 fabric 46