Brother International SE725 Operation Manual - Page 56

Utility Stitches ■ Darning Pull down the buttonhole lever as far as possible. e Gently hold the end of the upper thread in your left f hand, and then start sewing. 1 Reinforcement stitching Determine the desired length of the darning. a Set the button guide plate on buttonhole foot "A" to the desired length. (The distance between the markings on the presser foot scale is 5 mm (3/16 inch).) 1 2 1 Presser foot scale 2 Length of darning 3 5 mm (3/16 inch) 4 2.5 - 7.0 mm (3/32 - 1/ 4 inch) 3 4  Once sewing is completed, the machine automatically sews reinforcement stitches, then stops. Attach buttonhole foot "A". b Position the upper thread under the presser foot by guiding thread through the hole in the presser foot before attaching the buttonhole foot "A". Select a stitch. c No. 4-11 4-12 Stitch • For details, refer to "Stitch Chart" on page 41. Position the fabric so that the needle is 2 mm (1/16 d inch) in front of the area to be darned, and then lower the presser foot. 1 Tear 1 2 2 mm (1/16 inch) After sewing is finished, raise the presser foot lever, g remove the fabric, and then cut the threads. Raise the buttonhole lever to its original position. h ■ Eyelet stitching Eyelets, such as those on belts, can be sewn. Attach monogramming foot "N". a Select stitch. b No. 4-15 Stitch • For details, refer to "Stitch Chart" on page 41. Adjust either the stitch width or the stitch length to c select the desired eyelet size. • For details, refer to "Setting the stitch width" on page 35 and "Setting the stitch length" on page 35. Lower the needle into the fabric at the beginning of the d stitching, and then lower the presser foot lever. Start sewing. e  Once sewing is completed, the machine automatically sews reinforcement stitches, then stops. 2 54