Campbell Scientific CR1000KD CR1000 Measurement and Control System - Page 114

Section 7. Installation 'Define public variables Public RefTemp Public TC(6) 'Define Units Units RefTemp = degC Units TC = DegC Declare public variables, dimension array, and declare units. Declarations 'Define data tables DataTable(Temp,1,2000) DataInterval(0,10,min,10) Average(1,RefTemp,FP2,0) Average(6,TC(),FP2,0) EndTable Define data table 'Begin Program BeginProg 'Set scan interval Scan(1,Sec,3,0) 'Measurements PanelTemp(RefTemp,250) TCDiff(TC()...Offset) 'Processing (None in this 'example) Measure Scan loop 'Call data table CallTable Temp 'Controls (None in this 'example) 'Loop to next scan NextScan 'End Program EndProg Call data table 7.7.3.3 Command Line CRBasic programs are made up of a series of statements. Each statement normally occupies one line of text in the program file. Statements are made up of instructions, variables, constants, expressions, or a combination of these. "Instructions" are CRBasic commands. Normally, only one instruction is included in a statement. However, some instructions, such as If and Then, are allowed to be included in the same statement. Lists of instructions and expression operators can be found in the CRBasic Programming Instructions (p. 473) section. A full treatment of each instruction and 114