Campbell Scientific CR1000KD CR1000 Measurement and Control System - Page 145

Section 7. Installation CRBasic Example 22. Public I As Long Public A1, A2 Const ID = 10 BeginProg A1 = A2 + ID I = ID * 5 EndProg Constants to LONGs or FLOATs In CRBasic example Constants to LONGs or FLOATs (p. 145), I is an integer. A1 and A2 are FLOATS. The number 5 is loaded As FLOAT to add efficiently with constant ID, which was compiled As FLOAT for the previous expression to avoid an inefficient runtime conversion from LONG to FLOAT before each floating point addition. 7.7.3.9.4 Logical Expressions Measurements can indicate absence or presence of an event. For example, an RH measurement of 100% indicates a condensation event such as fog, rain, or dew. The CR1000 can render the state of the event into binary form for further processing, i.e., the event is either occurring (true), or the event has not occurred (false). True = -1, False = 0 In all cases, the argument 0 is translated as FALSE in logical expressions; by extension, any non-zero number is considered "non-FALSE." However, the argument TRUE is predefined in the CR1000 operating system to only equal -1, so only the argument -1 is always translated as TRUE. Consider the expression If Condition(1) = TRUE Then... This condition is true only when Condition(1) = -1. If Condition(1) is any other non-zero, the condition will not be found true because the constant TRUE is predefined as -1 in the CR1000 system memory. By entering = TRUE, a literal comparison is done. So, to be absolutely certain a function is true, it must be set to TRUE or -1. Note TRUE is -1 so that every bit is set high (-1 is &B11111111 for all four bytes). This allows the AND operation to work correctly. The AND operation does an AND boolean function on every bit, so TRUE AND X will be non-zero if at least one of the bits in X is non-zero, i.e., if X is not zero. When a variable of data type BOOLEAN is assigned any non-zero number, the CR1000 internally converts it to -1. The CR1000 is able to translate the conditions listed in table Binary Conditions of TRUE and FALSE (p. 146) to binary form (-1 or 0), using the listed instructions and saving the binary form in the memory location indicated. Table Logical Expression Examples (p. 146) explains some logical expressions. Non-Zero = True (Sometimes) Any argument other than 0 or -1 will be translated as TRUE in some cases and FALSE in other cases. While using only -1 as the numerical representation of 145