Campbell Scientific CR1000KD CR1000 Measurement and Control System - Page 45

Section 4. Quickstart Tutorial Figure 13: PC200W main window Table 3. PC200W EZSetup Wizard Example Selections Start the wizard to follow table entries. Screen Name Information Needed Introduction Provides and introduction to the EZSetup Wizard along with instructions on how to navigate through the wizard. Datalogger Type and Name Select the CR1000 from the scroll window. Accept the default name of "CR1000." PC COM Port Selection Select the correct PC COM port for the RS-232 connection. Typically, this will be COM1. Other COM numbers are possible, especially when using a USB-to-serial cable. Leave COM Port Communication Delay at 00 seconds. Note When using a USB-to-serial cable, the COM number may change if the cable is moved to a different USB port. This will prevent data transfer between the software and CR1000. Should this occur, simply move the USB cable back to the original port. If this is not possible, it will be necessary to close the PC200W software and open it a second time to refresh the available COM ports. Click on Edit Datalogger Setup and change the COM port to the new port number. Datalogger Settings Used to configure how the CR1000 communicates through the PC COM port. For this tutorial, accept the default settings. Communication Setup Summary Provides a summary of settings in previous screens. Communications Test A communications test between the CR1000 and PC can be performed in this screen. For this tutorial, the test is not required. Press Finish to exit the 45