Campbell Scientific CR1000KD CR1000 Measurement and Control System - Page 473

Appendix A. CRBasic Programming Instructions Read More! Parameter listings, application information, and code examples are available in CRBasic Editor (p. 109) Help. All CR1000 CRBasic instructions are listed in the following sub-sections. Select instructions are explained more fully, some with example code, in Programming Resource Library (p. 151). Example code is throughout the CR1000 manual. Refer to the table of contents Example index. A.1 Program Declarations AngleDegrees Sets math functions to use degrees instead of radians. Syntax AngleDegrees PipelineMode Configures datalogger to perform measurement tasks separate from, but concurrent with, processing tasks. Syntax PipelineMode SequentialMode Configures datalogger to perform tasks sequentially. Syntax SequentialMode SetSecurity Sets numeric password for datalogger security levels 1, 2, and 3. Executes at compile time. Syntax SetSecurity(security[1], security[2], security[3]) StationName Sets the station name internal to the CR1000. Does not affect data files produced by support software. See sections CRBasic example Miscellaneous Features (p. 243) demonstrates use of several CRBasic features: data type, units, names, event counters, flags, data intervals, and control. and CRBasic example Conditional Output (p. 251) demonstrates programming to output data to a data table conditional on a trigger other than time.. Syntax StationName(name of station) Sub / ExitSub / EndSub Declares the name, variables, and code that form a Subroutine. Argument list is optional. Exit Sub is optional. 473