Canon EOS C200 EOS C200 EOS C200B Instruction Manual - Page 43

Preparing the Camera Removing and Attaching the GR-V1 Camera Grip The camera grip comes originally attached to the C200; it is an optional accessory for the C200B. You can remove it and replace it with the thumb rest should the minimal configuration be necessary. 43 Removing the Camera Grip ባ 1 Set the Q switch to OFF. 2 Unscrew the camera grip's lock screw and gently detach the camera grip. • The camera grip contains an internal connection cable so be sure not to pull it too forcefully. ቤ 3 Remove the grip attachment ring and disconnect the camera grip's connection plug. • You can attach the grip attachment ring to the ብ connection cable so that you do not lose it. 4 Screw the thumb rest onto the camera. Attaching the Camera Grip The camera grip can be attached in a number of positions from 90° toward the lens to 60° toward the viewfinder at 6° intervals. 1 Set the Q switch to OFF. 2 Unscrew the thumb rest and remove it from the camera. 3 Lay the camera on a flat, stable surface with the rosette facing up. 4 Firmly insert the camera grip's plug all the way into the camera grip connection terminal on the camera. • Make sure to insert the plug all the way in, until the terminal is not visible. • If the plug is not correctly connected, all the controls on the camera may be disabled. 5 Attach the grip attachment ring. 6 Return the camera to an upright position, with the top side facing upward. 7 Attach the camera grip to the camera aligning it at the desired angle and tighten the camera grip's lock screw. ባ 60° ቦ ብ ቨ 0° 90°