Home » Canon Manuals » Projectors » Canon REALiS WX6500 Pro AV » Manual Viewer

Canon REALiS WX6500 Pro AV User Manual - Page 153

Error Notification Mails, Error list

Get Canon REALiS WX6500 Pro AV PDF manuals and user guides

View all Canon REALiS WX6500 Pro AV manuals

Add to My Manuals
Save this manual to your list of manuals

Page 153 highlights

Menu Description ■ Error Notification Mails The messages shown in the following error list are sent when an error occurs in the projector. Error list Errors related to temperature Errors related to the lamp Errors related to the fan Errors related to the air filter Errors related to the power Errors related to the lens connector Error name Text Error name Text Error name Text Error name Text Error name Text Error name Text Temperature abnormality The temperature inside the projector is too high for some reason or the outside air temperature is higher than the specified one. If the problem is inside the projector, check whether the projector is installed and operated normally, turn off the projector to cool its inside, and retry projection. If the same warning occurs again, the projector may be defective. Contact your dealer. Faulty lamp The lamp has burnt out. Replace the lamp with a new one. If the same warning occurs again, the lamp drive circuit may be defective. Contact your dealer. Faulty cooling fan The cooling fan or another component may be defective. Contact your dealer. Faulty air filter unit The air filter unit is not installed properly. Check whether the air filter unit is installed properly. If it is installed properly, the air filter unit detection switch may be defective. Contact your dealer. Faulty power supply The voltage of part of the power supply is abnormally high or any other problem has occurred in the power supply. Contact your dealer. Faulty lens connector The lens cable is not connected to the lens unit. Check whether the lens cable is connected to the lens unit properly. If it is connected properly, the lens connector or cable may be defective. Contact your dealer. Advanced Guide Menu Description 153

Section	Page
To Start Menu	2
Table of Contents	3
Projector Highlights	5
Safety Instructions	7
Safety Precautions	8
CAUTION ON HANGING FROM THE CEILING	8
READ AND KEEP THIS OWNER’S MANUAL FOR LATER USE.	9
AC Power Cord Requirement	11
Federal Communication Commission Notice	12
Precautions for Use	14
Installation and Handling Precautions	15
Precautions on the Lamp	17
Precautions for the Batteries of the Remote Control	18
For Safe Use	20
Before Installation	22
Precautions When Carrying/Shipping the Projector	22
Precautions for Installation	22
When Using Mounted on the Ceiling	24
Install Facing in the Correct Direction	25
Open Source Software	27
Software under the GNU General Public License Version 2	27
Before Use	28
Included Accessories	28
Part Names	29
Projector	29
Rear Side	29
Bottom Side	30
Side Control	30
LED Indicators	31
LED Indicator Displays	32
Input Terminal	33
Remote Control	35
Preparing the Remote Control	37
Installing Remote Control Batteries	37
Remote Control Operating Range	38
Using an Optional Wired Remote (RS-RC05)	38
Basic Guide	39
Installation Procedure	40
Setting Up the Projector	40
Positioning the Projector in Front of the Screen	40
Floor Installation	40
Installation Tilted Upward	40
Installation on High Surfaces	41
Ceiling Mounting or Rear Projection	41
Relationship Between Image Size and Projecting Distance	43
Lens Shift Function	47
Connection Procedure	49
Connecting a Computer	49
Connecting AV Equipment	51
Plugging the Projector In	52
Projection Procedure	53
Step 1 Turn the Projector On	53
When the Language Selection Screen Appears	54
When the Password Input Screen Appears	54
When “No signal” Appears	54
When Notebook Computer Screen Does Not Appear	54
Adjusting Image	54
Changing Notebook Computer Screen Output	55
Turning on External Monitor Output	55
Step 2 Select an Input Signal	56
Step 3 Adjust the Image	57
Setting the Display Resolution of the Computer	57
Windows 10	57
Windows 8 / 8.1	57
Windows 7	57
Windows Vista	58
Mac OS X	58
Auto PC Adjustment	58
Focusing, Resizing, or Moving the Image	59
Adjusting Image Focus	59
Adjusting Image Size	60
Adjusting the Image Position	61
Resetting the Position	62
Step 4 Select an Aspect Ratio (Screen Aspect) Matching the Screen	63
Step 5 Adjusting Keystone Distortion	67
Horizontal/Vertical Keystone Correction	67
Corner Adjustment	68
Resetting the Keystone Adjustment	69
Step 6 Select the Image Quality (Image Mode)	70
Image Modes	70
Selecting an Image Mode	71
Step 7 Turn the Projector Off	71
Convenient Features	72
Temporarily Blacking Out an Image	72
Freezing the Picture	72
Projecting Images Stored on a USB Flash Drive	72
Projecting a Test Pattern from the Menu	73
Set Power-Saving Settings	73
Adjusting the Volume	74
Muting the Sound	74
Zooming Part of an Image	75
Advanced Guide	77
Using Menus	78
Menu Configuration	78
Basic Menu Operations	79
Menu Configuration	81
Menu Description	90
Input settings	90
Aspect	91
Auto PC	91
Input signal select	91
Input signal settings	92
Split screen	93
Input level	93
Color space	94
Over scan	94
Progressive	95
Slideshow interval	95
Animation effect	95
Image adjustment	96
Image mode	97
Create profile	97
Brightness	98
Contrast	98
Sharpness	98
Gamma	98
Color adjustment	98
Advanced adjustment	99
Ambient light	99
Random noise reduction	99
MPEG noise reduction	100
Mosquito noise reduction	100
Dynamic gamma	100
Mem. color correct	100
6-axis color adjust	101
Fine-Tune Gamma	101
Lamp control	102
Lamp mode	102
Reset	103
Image priority	103
Install settings	104
Positional lock	105
Image flip H/V	105
Screen aspect	105
Zoom	106
Keystone	106
Digital image shift	107
Professional settings	107
Micro-digital image shift	107
Registration	107
Fan mode	108
Vertical projection	108
Edge blending	109
Lens - Position	112
Screen color	113
On screen	113
Menu position	113
Guide	113
Show input status	114
Overheat warning display	114
Menu display time	114
Lamp warning display	115
Air filter warning display	115
Split screen ID display	115
Test pattern	115
System settings	116
User screen settings	117
Logo capture	117
Logo position	117
No signal screen	117
Screen when blank	117
Projector on	118
Interface settings	118
Key repeat	118
Key lock	118
Remote control channel	119
Audio in terminal select	119
HDBaseT	120
Communication settings	120
HDMI image input	121
HDBaseT image input	121
Power management mode	121
Power management duration	122
Direct power on	122
Beep	122
Motion blur reduction	123
Language	123
Other settings	124
Password settings	124
Register password	125
[Fn] button settings	125
Gamma restore	125
Lamp counter	125
Air filter counter	126
Power counter	126
Firmware	126
Factory defaults	126
Network settings	127
Network Connection Overview	127
Connection Methods	127
Completing Projector Settings	129
Network settings lock	130
Network password setting	130
Register network password	130
Network standby settings	131
Network function	131
Detailed settings	132
PJLink	134
AMX Device Discovery	135
Crestron RoomView	135
Completing Computer Settings	136
Specifying an IP Address	136
Windows 10	136
Windows 8 / 8.1	137
Windows 7	138
Windows Vista	138
Mac OS X	139
Resetting the IP Address Setting of the Computer	139
Setting Up the Network	139
Displaying the Network Configuration Screen	139
Network Setting	141
Error Notification Mails	153
Controlling the Projector from a Computer	154
Checking Projector Information	156
Advanced Projection	157
Projecting Images on a USB Flash Drive	157
Description of USB File Browser	159
Selecting an Image for Projection	160
Selecting a Drive	160
Selecting a Folder	160
Selecting an Image File for Projection	160
Changing the View	160
Operating the Projected Image	160
Running a Slideshow of Data Saved in a USB Flash Memory	161
Creating an Image File Folder	161
Setting a Slideshow Interval	161
Split-Screen Display	161
Projecting from Multiple Projectors at Once (Edge Blending)	162
Basic Instructions	162
Color Adjustment	163
Black Level Adjustment	164
Smoother Overlapping Areas	165
Corner Adjustment	166
Other Information	169
Maintenance	170
Cleaning the Projector and the Air Filter	170
Cleaning the Air Filter	171
Replacing the Air Filter	172
Replacing the Lamp	173
Replacement Lamp	175
Lamp Replacement Procedure	176
Installing / Removing the Lens Unit	178
Installing the Lens Unit	178
Removing the Lens Unit	182
Product Specifications	183
Relationship between Aspect and Screen Aspect	183
When projecting at the original aspect ratio on a 16:10 screen	183
When projecting at the original aspect ratio on a 16:9 screen	184
When projecting at the original aspect ratio on a 4:3 screen	184
When projecting to fill a 16:10 screen	185
When projecting to fill a 16:9 screen	185
When projecting to fill a 4:3 screen	186
Displayed Test Patterns	187
Supported Signal Types	188
Projector	190
Remote Control	192
Specification of Each Lens Unit (Option)	192
External View	194
ANALOG PC-2 / COMPONENT Terminal	195
Service Port (CONTROL)	195
Troubleshooting	198
LED Indicator Details	198
Symptoms and Solutions	199
You Cannot Turn on the Projector	199
You Cannot Project an Image from the Projector	200
There is no Sound	201
The Projected Image Is Blurred	201
You Cannot Project an Image Appropriately	202
The Projector Power Turns Off	202
The Projector Cannot Join the Network	203
You Cannot Operate the Remote Control	204
Index	205
Numerics	205
A	205
B	205
C	205
D	205
E	205
F	205
G	205
H	205
I	205
K	205
L	205
M	206
N	206
O	206
P	206
R	206
S	206
T	206
U	206
V	206
W	206
Z	206