Canon VB-R12VE Network Video Recording Software RM Series Administrator s Manu - Page 80

(9) [Detection Indicator] Size marker Notification Indicator Colored bar The size marker changes position depending on the value of the [Area Ratio] setting. Adjust the motion detection settings while viewing the preview video and the Detection Indicator. The colored bar changes depending on the value of the [Sensitivity] and the [Area Ratio] settings. Color of the Colored Bar Green Red Meaning The detected motion does not reach the values specified in [Sensitivity] and [Area Ratio]. In this case, the colored bar remains to the left of the size marker. The detected motion exceeds the values specified in [Sensitivity] and [Area Ratio]. In this case, the colored bar remains to the right of the size marker. The other settings are the same as those for continuous recording (P. 75). Important • If the recording period for a schedule ends while motion detection recording is in progress, recording will stop. • The detection indicator is not affected by the [Duration] setting. Be sure to take the detection time into account when adjusting the motion detection settings. • To perform motion detection on the Storage Server, you must specify [JPEG] for the [Video Format]. Also, if you simultaneously use more than one recording mode, all the [Video Format] settings must be [JPEG]. An error message is displayed if you try to use a format other than [JPEG] and motion detection on the Storage Server at the same time. • Make the [Priority] setting on the [Recording Settings] tab lower than the priority of any of the other recording settings.  Intelligent Function Recording Settings Tabs named [Rule 1] through [Rule 15] are displayed, as shown. Each tab can be configured individually. (1) (2) (3) (1) [Do not record] Do not record even when the conditions for this rule are met. (2) [Start Recording] Start recording when the conditions for this rule are met. After selecting the item, configure the recording settings below the item. 80