Canon VB-S905F Network Camera VB-S30D/VB-S31D/VB-S800D/VB-S805D/VB-S900F/VB-S9 - Page 40
[Network] Setting Administrator Password, LAN, IP Address, DNS, etc, Administrator Password
View all Canon VB-S905F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
[Network] Setting Administrator Password, LAN, IP Address, DNS, etc The following can be set here. • Administrator Password Set the administrator password. • LAN Set the IP address and other items needed to establish a LAN connection. • IPv4 Set IPv4 address. • IPv6 Set IPv6 address. • DNS Set the name server address, host name and DDNS registration. • mDNS This will configure settings for using multicast DNS. • SNMP Configure the necessary settings to use SNMP. Administrator Password (1) [Password] Set the administrator password. Up to eight (singlebyte) ASCII characters (space or printable characters) can be used. The factory default setting is "camera". If the Admin Viewer, Admin Tools, etc., are connected, terminate the connection before changing the password. (2) [Confirm Password] Enter the same password as above for confirmation. Important • To ensure system security, be sure to change the administrator password. If it is not changed, a message prompting change of the password will appear continuously in the upper portion of the Setting Menu. The message will not disappear until the password is changed. Do not forget the new password. • Press the reset switch to restore factory default settings if you have forgotten the administrator password (p. 167). Note, however, that this will reset all camera settings to factory default settings except for date and time. • [Administrator Password] and [Access Control] > [Administrator Password] (p. 64) are the same. If you set one [Administrator Password], the setting will be reflected in the other [Administrator Password]. LAN (1) [LAN Interface] Select [Auto], [Full Duplex] or [Half Duplex]. Normally [Auto] is used. (2) [Maximum Packet Size] Enter the maximum transmission unit. Normally there is no need to change the default setting of 1500. Important • The camera may become inaccessible from the active web browser if [LAN Interface] or [Maximum Packet Size] settings are changed. Check beforehand the precautions in "Important" in "[Reboot Item] Setting Items Requiring Rebooting" (p. 76). • Set [Maximum Packet Size] to 1280 or greater if using IPv6. Note When using ADSL, setting the maximum packet size to a slightly lower value may increase sending efficiency. IPv4 (1) [IPv4 Address Setting Method] Select [Manual] or [Auto (DHCP)] in the address setting method. If [Manual] is selected, directly enter the values according to the environment in which the camera is used. If [Auto (DHCP)] is selected,the value automatically acquired from the DHCP server will be entered in [IPv4 Address],[Subnet Mask] and [IPv4 Default Gateway Address]. (2) [IPv4 Address] If [Manual] is specified in (1), enter a fixed IP address. (3) [Subnet Mask] If [Manual] is specified in (1), enter the designated subnet mask values for each network. 40