Canon Vb-C60 NETWORK CAMERA VB-C60 Operation Guide - Page 104

Motion Detection Setting Tool (1) (2) (1)Setting Frame Rate When this check box is selected, the camera's frame rate for motion detection can be changed. Enter a desired rate in a range of fps 0.5 to 30.0. (2)Enable preset selection When this check box is selected, you can select the camera position using a preset. Note The value set in [Maximum Frame Rate: Image Transmission] ( P. 1-22) must be greater than the frame rate set by this tool. Tip z If the network load is heavy, the specified frame rate may not be achieved. z By setting a lower frame rate, the video extracted from the captured video will be included in the scope of motion detection. This way, you can also perform motion detection for slowmoving subjects, etc. z The frame rate set here is applied only to motion detection. z Presets outside the view restriction are not shown in the preset list. 3. Set the motion detection area ([Area] tab). Up to four motion detection areas can be created, where the frame of each area can be resized/moved by dragging. To resize the frame, drag "„" at four corners/on four sides. To move the frame, drag a point inside the frame. You can also set a separate motion detection level for each area. This camera lets you set the motion detection level while playing the video recorded in the [Live] tab ( P. 2-43). 2-38