Canon imagePROGRAF iPF510 iPF510 User Manual - Page 67

Control Panel Med.Detail Set. Setting Item (The paper type is Roll DryingTime displayed here.) (*1) Scan Wait Time Feed Priority Adjust Length Head Height Skew Check Lv. VacuumStrngth NearEnd RllMrgn Cut Speed Trim Edge First Description, Instructions Specify the time to wait for the ink to dry for each sheet. Specify the time to wait for the ink to dry between each scan in bidirectional printing, in consideration of how quickly the paper absorbs ink. Note that printing will take longer if you specify a wait time. Specify exact paper feeding, if desired. Normally, select Automatic. Choose Print Length if you prefer to feed the paper an exact amount. However, note that choosing Print Length may result in slight banding in the direction of Carriage scanning. Displayed if Feed Priority is Print Length. Adjustment relative to the amount of stretching or shrinkage of the current paper. For paper that tends to stretch, increase the feed amount by setting the adjustment value toward +. For paper that tends to shrink, decrease the feed amount by setting the adjustment value toward -. The setting for the amount of paper stretching or shrinkage is relative. If you access it again later, it will be displayed as 0.00%. Adjust the Printhead height. (→P.586) If you print on Japanese Paper Washi or other handmade paper that has an irregular width, choose Loose for a higher skew detection threshold, or choose Off to disable skew detection. However, if paper is loaded askew when detection is Off, note that paper jams or Platen soiling may occur. If strict skew detection is required, choose High Accuracy. Specify the level of suction that holds paper against the Platen. (→P.598) Specify a margin at the leading edge of roll paper to ensure better printing quality at the leading edge. Note that if you choose 3mm, it may lower the printing quality at the leading edge and affect feeding accuracy. The printed surface may be scratched, and ink may adhere to the leading edge. Choose the cutting speed. For media such as lm that are more likely to generate debris when cut, choose Fast to reduce the amount of debris. If a roll is loaded, the end of the paper will be cut. Choose On to have 40 mm (1.6 in) cut off the leading edge of the roll every time after you load the roll. Scraps are then removed. When Automatic is selected, if the left and right side of the leading edge of the roll are uneven (by 3 mm [0.12 in] or more), the edge is cut an amount relative to the slant to ensure a straight edge after you load the roll. Scraps are then removed. If the unevenness is less than 3 mm or if Off is selected, the edge is not cut and scraps are not removed. Printer Parts 53