Cisco WS-C4003 Software Guide - Page 260
IP Permit List Default Configuration, Configuring the IP Permit List, Adding IP Addresses to the IP
View all Cisco WS-C4003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 260 highlights
IP Permit List Default Configuration Chapter 17 Configuring the IP Permit List You can specify the same IP address in more than one entry in the permit list if the masks are different. The mask is applied to the address before it is stored in NVRAM, so that entries that have the same effect (but different addresses) are not stored. When you add such an address to the IP permit list, the system displays the address after the mask is applied. IP Permit List Default Configuration Table 17-1 shows the default IP permit list configuration. Table 17-1 IP Permit List Default Configuration Feature IP permit list enable state Permit list entries IP syslog message severity level SNMP IP permit trap (ippermit) Default Value Disabled None configured 2 Disabled Configuring the IP Permit List These sections describe how to configure IP permit list: • Adding IP Addresses to the IP Permit List, page 17-2 • Enabling IP Permit List, page 17-3 • Disabling the IP Permit List, page 17-4 • Clearing an IP Permit List Entry, page 17-4 Adding IP Addresses to the IP Permit List An IP address can be added to the SNMP permit list, the Telnet permit list, or both lists. To add IP addresses to an IP permit list, perform this task in privileged mode: Step 1 Step 2 Task Specify the IP addresses to add to the IP permit list. Verify the IP permit list configuration. Command set ip permit ip_address [mask] [all | snmp | telnet | ssh] show ip permit Note You can use the set security acl command to more efficiently set permit lists. This example shows how to add IP addresses to IP permit list and verify the configuration: Console> (enable) set ip permit 172.16.0.0 255.255.0.0 telnet 172.16.0.0 with mask 255.255.0.0 added to Telnet permit list. Console> (enable) set ip permit 172.20.52.32 255.255.0.0 snmp 172.20.52.32 with mask 255.255.0.0 added to Snmp permit list. 17-2 Software Configuration Guide-Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4 78-12647-02