Cisco WS-C4003 Software Guide - Page 275

Chapter 19 Checking Port Status and Connectivity Using Telnet Security Membership Fast start QOS scheduling CoS rewrite ToS rewrite Rewrite UDLD Inline power AuxiliaryVlan SPAN yes static,dynamic yes rx-(none),tx-(2q1t) no no no yes no 1..1000,untagged,none source,destination . . . This example shows you how to display the port capabilities for port 5 on module 3: Console> (enable) show port capabilities 3/5 Model WS-X4148 Port 3/5 Type 10/100BaseTX Speed auto,10,100 Duplex half,full Trunk encap type 802.1Q Trunk mode on,off,desirable,auto,nonegotiate Channel 3/1-48 Flow control no Security yes Membership static,dynamic Fast start yes QOS scheduling rx-(none),tx-(2q1t) CoS rewrite no ToS rewrite no Rewrite no UDLD yes Inline power no AuxiliaryVlan 1..1000,untagged,none SPAN source,destination Console> (enable) Using Telnet You can access the switch command-line interface (CLI) using Telnet. In addition, you can use Telnet from the switch to access other devices in the network. Up to eight simultaneous Telnet sessions are possible. Before you can open a Telnet session to the switch, you must first set the IP address (and in some cases the default gateway) for the switch. For information about setting the IP address and default gateway, see Chapter 3, "Configuring the Switch IP Address and Default Gateway." To Telnet to another device on the network from the switch, perform this task in privileged mode: Task Open a Telnet session to a remote host. Command telnet host [port] 78-12647-02 Software Configuration Guide-Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4 19-5