Cisco WS-C4003 Software Guide - Page 45
ROM Monitor Command-Line Interface, Catalyst4003 Bootup Display Example
View all Cisco WS-C4003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Chapter 2 Using the Command-Line Interface ROM Monitor Command-Line Interface ROM Monitor Command-Line Interface The ROM monitor is a ROM-based program that executes when the switch is powered on, reset, or when a fatal exception occurs. The system enters ROM monitor mode if the nonvolatile RAM (NVRAM) configuration is corrupted, if the switch does not find a valid system image or if the configuration register is set to enter ROM monitor mode. From the ROM monitor mode, you can load a system image manually from Flash memory or the network interface (me1). You can enter ROM monitor mode by pressing Ctrl-C within the first 5 seconds of startup. Once you are in ROM monitor mode, the prompt changes to rommon>. Enter the ? command to see the available ROM monitor commands. Note For complete descriptions of all ROM monitor commands, refer to the Command Reference-Catalyst 4000 Family, Catalyst 2948G, and Catalyst 2980G Switches. Catalyst 4003 Bootup Display Example This example shows the bootup display of a Catalyst 4003 switch. The display on the Catalyst 4912G, the Catalyst 2948G, and the Catalyst 2980G switches will be similar. WS-X4012 bootrom version 4.5(1), built on 1999.03.29 21:04:04 H/W Revisions: Meteor: 4 Comet: 8 Board: 2 Supervisor MAC addresses: 00:d0:58:70:a1:00 through 00:d0:58:70:a4:ff (1024 addr esses) Installed memory: 32 MB Testing LEDs.... done! The system will autoboot in 5 seconds. Type control-C to prevent autobooting. rommon 1 > The system will now begin autobooting. Autobooting image: "bootflash:cat4000.5-1-1a.bin" CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC CCCCCCCCCCCCCC Starting Off-line Diagnostics Mapping in TempFs Board type is WS-X4012 DiagBootMode value is "post" Loading diagnostics... Power-on-self-test for Module 1: WS-X4012 Status: (. = Pass, F = Fail) processor: . cpu sdram: . enet console port: . nvram: . switch registers: . switch port 0: . switch port 2: . switch port 3: . switch port 5: . switch port 6: . switch port 8: . switch port 9: . switch port 11: . switch bandwidth: . temperature sensor: . switch sram: . switch port 1: . switch port 4: . switch port 7: . switch port 10: . Module 1 Passed Power-on-self-test for Module 2: WS-X4148 Port status: (. = Pass, F = Fail) 1: . 2: . 3: . 4: . 5: . 6: . 7: . 9: . 10: . 11: . 12: . 13: . 14: . 15: . 17: . 18: . 19: . 20: . 21: . 22: . 23: . 8: . 16: . 24: . 78-12647-02 Software Configuration Guide-Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4 2-9