D-Link DES-3228PA Installation Guide - Page 23
Initial Configuration, General Configuration Information, Auto-Negotiation - manual
UPC - 790069296352
View all D-Link DES-3228PA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Initial Configuration Section 3. Initial Configuration This section describes the initial device configuration and includes the following topics: • General Configuration Information • Booting the Switch • Configuration Overview • Advanced Configuration • Software Download and Reboot • Startup Menu Functions After completing all external connections, connect a terminal to the device to monitor the boot and other procedures. The order of installation and configuration procedures is illustrated in the following figure. For the initial configuration, the standard device configuration is performed. Other functions can be performed, but doing so suspends the installation process and causes a system reboot. Performing other functions is described later in this section. General Configuration Information Your device has predefined features and setup configuration. Auto-Negotiation Auto-negotiation allows a device to advertise modes of operation and share information with another device that shares a point-to-point link segment. This automatically configures both devices to take maximum advantage of their abilities. Auto-negotiation is performed completely within the physical layers during link initiation, without any additional overhead to either the MAC or higher protocol layers. Auto-negotiation allows the ports to do the following: • Advertise their abilities • Acknowledge receipt and understanding of the common modes of operation that both devices share • Reject the use of operational modes that are not shared by both devices • Configure each port for the highest-level operational mode that both ports can support If connecting a port of the switch to the Network Interface Card (NIC) of a terminal that does not support autonegotiation or is not set to auto-negotiation, both the device port and the NIC must be manually set with the Web browser interface or CLI commands to the same speed and duplex mode. Note If the station on the other side of the link attempts to auto-negotiate with a port that is manually configured to full duplex, the auto-negotiation results in the station attempting to operate in half duplex. The resulting mismatch may lead to significant frame loss. This is inherent in the auto-negotiation standard. Page 22