D-Link DPG-2000W Product Manual - Page 13

Using the DPG-2000W (Continued) Depending on the type of RF activity detected, you will see any one of the following messages displayed: RF activities detected on other channels (none). No other 802.11g channels detected in use other than the DPG-2000W. Your connection to the DPG-2000W should be smooth and error free. RF activities detected on other channels (8, 9). Existing 802.11b channels detected in use, but there is no interference. Your connection to the DPG-2000W should be smooth and error free. RF activities detected on other channels (1, 5, 8, 11). WARNING: Interference. Existing channels detected and interference found. The DPG-2000W is in a RF noisy environment, you may have trouble connecting and maintaining connections to the DPG-2000W even if a connection can be made. Note: The DPG-2000W updates this information whenever the banner page appears on boot-up. In a noisy environment, channel information might get outdated quickly since the DPG-2000W does not monitor channels continuously. Once you have turned the DPG-2000W on and noted the above information, you can now configure your computer to connect to the DPG-2000W. Establishing a Link with the DPG-2000W Before starting the Presentation Session Manager, the network interface of the computer must have a valid IP address. For computers running DHCP client mode while DHCP server is unavailable, it may take a few moments for the computers to obtain a system IP address. If a valid IP address for the network interface cannot be obtained, please refer to a network administrator for how to assign an IP address. Note: The computer's network interface must have a valid IP address before PSM starts. 13