D-Link DWS-4026 Product Manual - Page 446

D-Link Unified Access System Software User Manual 12/10/09 • The AP has been rebooted since the channel plan was computed and acquires a static channel that has been set statically via local database. • The channel has been set manually through the advanced page. • The auto-channel mode has been disabled in the profile for this AP. Initiating Manual Power Adjustments If you select Manual as the Power Adjustment Mode on the Configuration tab, you can manually initiate the power adjustment algorithm on the Manual Power Adjustments page. Figure 307: Manual Power Adjustments The Current Status of the plan shows one of the following states: • None: The power adjustment algorithm has not been manually run since the last switch reboot. • Algorithm In Progress: The power adjustment algorithm is running. • Algorithm Complete: The power adjustment algorithm has finished running. A table displays to indicate proposed power adjustments. Each entry shows the AP along with the current and new power levels. To accept the proposed change, click Apply. You must manually apply the power adjustment for the proposed assignments to be applied. • Apply In Progress: The switch is adjusting the power levels that the APs use. • Apply Complete: The algorithm and power adjustment are complete. ACCESS POINT SOFTWARE DOWNLOAD The Unified Switch can upgrade software on the APs that it manages. The Cluster Controller can update code on APs managed by peer wireless switches. To upgrade one or more AP from the switch that manages it, click the WLAN > Administration > AP Management > Software Downloads tab. Page 446 AP Management Document 34CSFP6XXUWS-SWUM100-D7