D-Link DWS-4026 Product Manual - Page 448

D-Link Unified Access System Software User Manual 12/10/09 Field Managed AP Status (Global) Status (per-AP) Download Count Success Count Failure Count Abort Count Table 272: Software Download (Cont.) Description The list shows all the APs that the switch manages. If the switch is the Cluster Controller, then the list shows the APs managed by all switches in the cluster. Each AP is identified by its MAC address, IP address, and Location in the format. To upgrade a single AP, select the AP MAC address from the drop down list. To upgrade all APs, select All from the top of the list. If All is selected, the Group Size field will limit the number of simultaneous AP upgrades in order not to overwhelm the TFTP server. To select multiple APs to upgrade, CTRL + click the APs to upgrade. Note: D-Link recommends that you upgrade all managed APs at the same time. The following fields display after you click Start: The status of the upgrade process for all APs: • Not Started: The Unified Switch has not started the download process. • Requested: A request to download AP software has been made, but the switch has not done any downloads. • Code Transfer in Progress: A download is in progress. • Failure: Download failed on all APs. • Aborted: Download was aborted before the AP loaded code from the TFTP server. • NVRAM-Update-in-Progress: Download completed successfully. The reset command has been sent to the AP. • Success: All APs are connected to the Unified Switch. A table also appears and lists each AP, its download status, and the software version it is downloading. The status for an individual AP can have one of the following values: • Requested: A download is planned for this AP, but the AP is not in the current download group, so it hasn't been told to start the download yet. • Code-Transfer-In-Progress: The AP has been told to download the code. • Failure: The AP reported a failing code download. • Aborted: The download was aborted before the AP loaded code from the TFTP server. • Waiting-For-APs-To-Download: A download finished on this AP, and it is waiting for other APs to finish download. Reset command is not sent to the AP in this state. • NVRAM-Update-In-Progress: Download completed successfully. The reset command sent to the AP. • Timed-Out: The AP did not reconnect to the Unified Switch in the fixed time interval. The number of managed APs to download software in the current download request. If you selected All for the managed APs to upgrade, the download count shows the number of managed APs at the time the download request was started. The value is 1 if only one AP is being updated. The number of APs that have successfully downloaded the new code. This value starts with 0 at the beginning of the download and increases by one for every AP that successfully downloaded the code. The number of APs that failed to download the new code starting at 0 and incrementing with each failure. The number of APs for which the download was aborted, starting at 0 and incrementing each aborted download. MANAGED AP ADVANCED SETTINGS When the AP is in Managed mode, remote access to the AP is disabled. However, you can enable Telnet access by enabling the Debug feature on the AP Management > Advanced Settings page. From the Managed AP Advanced Settings page, Page 448 AP Management Document 34CSFP6XXUWS-SWUM100-D7