D-Link DXS-3250E Installation Guide - Page 36
Advanced Configuration, Retrieving an IP Address From a DHCP Server
UPC - 790069308420
View all D-Link DXS-3250E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Initial Configuration Advanced Configuration Console# configure Config(config)# snmp-server community private rw 11.1.1.2 type router Config(config)# exit Console(config)# show snmp Community-String Community-Access IP address ---------- private readWrite 11.1.1.2 Traps are enabled. Authentication-failure trap is enabled. Trap-Rec-Address Trap-Rec-Community Version ------- System Contact: System Location: This completes the initial configuration of the device from a local terminal. The configured parameters enable further device configuration from any remote location. Advanced Configuration This section provides information about dynamic allocation of IP addresses and security management based on the authentication, authorization, and accounting (AAA) mechanism, and includes the following topics: • Configuring IP Addresses through DHCP • Configuring IP Addresses through BOOTP • Security Management and Password Configuration When configuring/receiving IP addresses through DHCP and BOOTP, the configuration received from these servers includes the IP address, and may include subnet mask and default gateway. Retrieving an IP Address From a DHCP Server When using the DHCP protocol to retrieve an IP address, the device acts as a DHCP client. To retrieve an IP address from a DHCP server, perform the following steps: 1. Select and connect any port to a DHCP server or to a subnet that has a DHCP server on it, in order to retrieve the IP address. 2. Enter the following commands to use the selected port for receiving the IP address. In the following example, the commands are based on the port type used for configuration. console# configure console(config)# interface ethernet g1 console(config-if)# ip address dhcp hostname console(config-if)# exit console(config)# The interface receives the IP address automatically. 1. To verify the IP address, enter the show ip interface command at the system prompt as shown in the following example. Console# show ip interface Gateway IP Address Type Activity status Page 36