Dell Brocade 300 Fabric OS Command Reference v7.1.0 - Page 121
DIAGNOSTICS, EXAMPLES, SEE ALSO, itemList, portLoopbackTest
View all Dell Brocade 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
bpPortLoopbackTest 2 DIAGNOSTICS EXAMPLES SEE ALSO 8 16 -bpports itemlist Runs test at 8 Gbps (Default for Condor2). Runs test at 16 Gbps (Condor3 only). Specifies a list of blade ports to test. By default all valid blade ports in the specified blade are tested. On the Brocade Encryption platforms, ports 80-103 are the only valid ports, because these are the only blade ports with access to the Vader chip. Refer to the itemList help page for further information on the itemlist parameter. When it detects failures, the test may report one or more of the following error messages. If errors persist, contact Technical Support. DATA Data received does not match the data sent. ERRSTAT Errors were found in the ASIC statistics. INIT Port failed to initialize. PORTDIED A previously initialized port went to an un-initialized state. STATS Errors were found in the ASIC statistics. TIMEOUT Did not receive a frame in the given timeout period. XMIT Frame transmission failure. To run the test on blade ports 80-90 with one frame: switch:admin> bpportloopbacktest -bpports 80-90 -nframes 1 Running bpportloopbacktest Ram Init Ob1 portloopbacktest on ports 80-90 lbMode 7 speed 4 Info: Vader port 0 recovering Rx Fifo Info: Vader port 1 recovering Rx Fifo Info: Vader port 2 recovering Rx Fifo Info: Vader port 3 recovering Rx Fifo Info: Vader port 4 recovering Rx Fifo Info: Vader port 5 recovering Rx Fifo Ob1 portloopbacktest on ports 80-90 PASSED Test Complete: bpportloopbacktest Pass 1 of 1 Duration 0 hr, 0 min & 24 sec (0:0:24:599). Cleaning up after test....... passed. itemList, portLoopbackTest Fabric OS Command Reference 93 53-1002746-01