Dell Brocade 300 Fabric OS Command Reference v7.1.0 - Page 693
portCfgEncrypt, portcfgencrypt --enable, portEncCompShow, enable, disable
View all Dell Brocade 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 693 highlights
portCfgEncrypt 2 portCfgEncrypt Configures a port for encryption. SYNOPSIS portcfgencrypt --enable [slot]/port portcfgencrypt --disable [slot]/port portcfgencrypt --help DESCRIPTION NOTES OPERANDS EXAMPLES Use this command to configure a port for encryption. This command enables or disables the encryption configuration on the specified port and saves the configuration persistently. Before you can configure a port for encryption, you must configure the port for authentication. When disabling encryption, you must disable the encryption configuration before you can disable authentication. Refer to the Fabric OS Encryption Administrator's Guide for more information. Configuring a port for encryption is disruptive. You must disable the port before you can enable encryption on the port. This command fails on an enabled port. The number of configurable ports is limited per ASIC. Use the portEncCompShow for a listing of configurable ports per ASIC. This command is supported on E_Ports and EX_Ports. An E_Port or EX_Port can be enabled for compression and for encryption at the same time. When you move a configured port to another logical switch, you are informed that the operation requires that the port configuration be disabled. You are given the choice to cancel the move or to continue. If you want to go ahead with the move and the port is configured for encryption or compression, you must disable the configuration prior to moving the port. You must reconfigure the port on the target switch if you want to use compression or encryption on that port. This command is supported only on Condor 3-based platforms running Fabric OS v7.0.0 or later with the exception of the Brocade 6505 switch and the Brocade FC8-32E and Brocade FC8-48E port blades. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: slot On bladed systems only, specifies the slot number of the ports to be configured, followed by a slash (/). port Specifies the port to be configured. --enable Enables the encryption configuration on the specified port. --disable Disables the encryption configuration on the specified port. --help Displays the command usage. To enable the encryption configuration: switch:admin> portcfgencrypt --enable 2 Fabric OS Command Reference 665 53-1002746-01