Dell Brocade 300 Fabric OS Command Reference v7.1.0 - Page 637
perfSetPortEEMask
View all Dell Brocade 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 637 highlights
perfSetPortEEMask 2 perfSetPortEEMask Sets the overall mask for end-to-end (EE) performance monitors. SYNOPSIS perfsetporteemask [slot/]port "TxSIDMsk " "TxDIDMsk " "RxSIDMsk" "RxDIDMsk" DESCRIPTION NOTES OPERANDS Use this command to set the mask for an end-to-end (EE) performance monitor. This command allows selecting the Fibre Channel frames for which to collect performance statistics. When setting the EE mask on a port, all existing EE monitors on that port are deleted. This command controls all three address fields (Domain ID, Area ID, and AL_PA ID) of both the source ID and destination ID, which can be used to trigger the monitor. The address mask is of the form "dd:aa:pp", where "dd" is the Domain ID mask, "aa" is the Area ID mask, and "pp" is AL_PA ID mask. Specify the following values to turn a specific field on or off: 00 Specifies that the field does not trigger EE monitors. ff Specifies that the field does trigger EE monitors. The default EE mask value is 0xffffff. When a mask is set (0xff), the corresponding field triggers the monitor. If the mask is unset (0x00), the corresponding field is ignored. For example, "00:ff:00" uses only the Area ID to trigger the EE monitor. There is only one EE mask per port. The mask is applied to all eight EE monitors available on a port. The default EE mask value upon power-on is already set. When ISL monitoring is enabled, the EE mask on E_Ports is controlled automatically and existing mask values for E_Ports are over-written. This command requires an Advanced Performance Monitoring license. This command is not supported on virtual FC ports (VE/VEX_Port), EX_Port, M (Mirror) ports and GbE ports. The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for details. This command has the following operands: slot For bladed systems only, this operand specifies the slot number of the port on which the monitor is to be updated, followed by a slash (/). port Specifies the number of the port on which the EE mask is to be updated, relative to its slot for bladed systems. Use switchShow for a list of valid ports. TxSIDMsk Specify the transmitting source ID mask in dd:aa:pp format, with quotation marks, where dd is the domain ID mask, aa is the Area ID mask, and pp is AL_PA ID mask. For example, "00:ff:00" uses only the Area ID to trigger the EE monitor. Specify the following values to turn a specific field on or off: 00 Specifies that the field does not trigger EE monitors. Fabric OS Command Reference 609 53-1002746-01