Dell Brocade 815 Brocade Adapters Installation and Reference Manual - Page 25

• Install logs • Core files • Details on the CNA or Fabric Adapter Ethernet interface, including IP address and mask. • Status and states of all adapter ports, including the Ethernet, FCoE, and DCB ports on CNAs and Fabric Adapters. • DCB status and statistics for CNAs and Fabric Adapters • Network driver information, Ethernet statistics, offload parameters, and flow control coalesce parameters for CNAs and Fabric Adapters. • Ethernet offload and flow control parameters for CNAs and Fabric Adapters. NOTE Before collecting data through the Support Save feature, you may want to disable auto-recovery on the host system. When adapters are reset after an auto-recovery from a failure, traces initiated before the failure may be lost or overwritten. To disable auto-recovery, use the following commands: • For Linux, use the following commands, then reboot the system: - To disable auto-recovery for the network (BNA) driver. insmod bna.o bnad_ioc_auto_recover=0 - To disable auto-recovery for the storage (BFA) driver. insmod bfa.o ioc_auto_recover=0 • For VMware, use the following commands. - To unload and load the network (BNA) driver with IOC auto-recovery disabled, use the following commands: esxcfg-module -u bna esxcfg-module bna bnad_ioc_auto_recover=0 - To disable IOC auto-recovery for the network (BNA) driver across reboots, use the following command: esxcfg-module -s "bnad_ioc_auto_recover=0" bna - To disable IOC auto-recovery for the storage (BFA) driver across reboots, use the following command: esxcfg-module -s "ioc_auto_recover=0" bfa • For Windows use the Registry Edit tool (regedt32) or the BCU drvconf --key command. Following is the drvconf ---key command: bcu drvconf --key ioc_auto_recover --val 0 • For Solaris, edit /kernel/drv/bfa.conf using the following command: ioc-auto-recover=0 NOTE Brocade 804 and 1007 adapters are not supported on Solaris systems. Brocade Adapters Installation and Reference Manual xxv 53-1002144-01