Dell Force10 S55T Installing the S55 System - Page 5

1 About this Guide This guide provides site preparation recommendations, step-by-step procedures for rack mounting and desk mounting, inserting optional modules, and connecting to a power source. After you have completed the hardware installation and power-up of the S55, refer to the FTOS Configuration Guide for the S55 for software configuration information and the FTOS Command Reference for the S55 for Command Line Interface (CLI) information. NOTE: The S55 requires FTOS version 8.3.5.0. Refer to the S55 Release Notes for information on upgrading the system, if necessary. Contact Dell Force10 Technical Support with any questions regarding FTOS versions and upgrades. CAUTION: Wear grounding wrist straps when handling this equipment to avoid ESD damage. WARNING: The installation of this equipment shall be performed by trained and qualified personnel only. Read this guide before installing and powering up this equipment. This equipment contains two power cords. Disconnect both power cords before servicing. WARNING: This equipment contains optical transceivers, which comply with the limits of Class 1 laser radiation. WARNING: Visible and invisible laser radiation may be emitted from the aperture of the optical transceiver ports when no cable is connected. Avoid exposure to laser radiation and do not stare into open apertures. Information symbols and warnings The following graphic symbols are used in this document to bring attention to hazards that exist when handling the S55 and its components. Please read these alerts and heed their warnings and cautions. Table describes symbols contained in this guide. Table 1-1. Information Symbols Symbol Warning Description Note This symbol informs you of important operational information. Caution Warning This symbol informs you that improper handling and installation could result in equipment damage or loss of data. This symbol signals information about hardware handling that could result in injury. About this Guide | 5