Dell Inspiron 16 7610 Service Manual for computers with two fans - Page 28

Installing the battery

Page 28 highlights

Steps 1. Peel the tape that secures the battery cable to the battery. 2. Disconnect the battery cable from the system board. 3. Remove the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly. 4. Lift the battery off the palm-rest and keyboard assembly. Installing the battery Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task NOTE: This procedure applies to both 3-cell and 6-cell battery configurations that can be installed in your computer. The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure. 28 Removing and installing components

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77

Steps
1.
Peel the tape that secures the battery cable to the battery.
2.
Disconnect the battery cable from the system board.
3.
Remove the five screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
4.
Lift the battery off the palm-rest and keyboard assembly.
Installing the battery
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
NOTE:
This procedure applies to both 3-cell and 6-cell battery configurations that can be installed in your computer.
The following image(s) indicate the location of the battery and provides a visual representation of the installation procedure.
28
Removing and installing components