Dell Inspiron 16 7635 2-in-1 Owners Manual - Page 56
Installing the I/O board
![]() |
View all Dell Inspiron 16 7635 2-in-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Steps 1. Remove the two screws (M2.5x5) and the screw (M2x4) that secure the left display hinge to the palm-rest and keyboard assembly. 2. Pry open the left display hinge to an angle of 90 degrees. 3. Peel the tape that secures the I/O-board connector latch to the I/O board. 4. Lift the I/O-board cable-connector latch and disconnect the I/O-board cable from the I/O board. 5. Disconnect the coin-cell battery cable from the I/O board. 6. Lift the latch and disconnect the power-button board cable from the I/O board. 7. Remove the two screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly. 8. Lift the I/O board off the palm-rest and keyboard assembly. Installing the I/O board CAUTION: The information in this section is intended for authorized service technicians only. Prerequisites If you are replacing a component, remove the existing component before performing the installation process. About this task The following images indicate the location of the I/O board and provides a visual representation of the installation procedure. 56 Removing and installing Field Replaceable Units (FRUs)
![](/manual_guide/products/dell-inspiron-16-7635-2in1-owners-manual-bee1542/56.png)