Dell N3200-ON Networking N-Series Switches User Guide version 6.8.0 - Page 1401

console(config-router)#neighbor 129.168.0.254 remote-as 65001 console(config-router)#network 129.168.0.0 mask 255.255.0.0 routemap Inject-MED console(config0router)#redistribute connected console(config-router)#exit Configuring Communities in BGP The following example configures an egress routing policy that sets the community attribute for matching routes. In the example, VLAN 10 is created, followed by an access list Comm-Hosts matching directly connected source address 5.5.5.x for which the community attribute will be injected into the advertised routes. A route map "Subnet-5-5-5" is created. This route map sets the match criteria as ACL Comm-Hosts and configures the community attribute 65001:300 for the matching routes. Interface Gi1/0/1 is configured as a member of VLAN 10, VLAN 10 is assigned an IP address, IP routing is enabled, and BGP router 65001 is created with a router ID of 129.168.1.254. An iBGP neighbor 129.168.0.254 with a remote AS of 65001 is configured (this is an iBGP configuration). BGP is configured to send the community attribute and to use the Subnet-5-5-5 match criteria as an egress policy. console#configure console(config)#vlan 10 console(config-vlan)#exit console(config)#ip prefix-list Comm-Hosts seq 10 permit 5.5.5.0 255.255.255.0 console(config)#ip bgp-community new-format console(config)#route-map "Subnet-5-5-5" permit 100 console(route-map)#match ip address prefix-list Comm-Hosts console(route-map)#set community 65001:300 additive console(route-map)#exit console(config)#interface gi1/0/1 console(config-if-Gi1/0/1)#switchport access vlan 10 console(config-if-Gi1/0/1)#exit console(config)#interface vlan 10 console(config-if-vlan10)#ip address 129.168.10.2 /24 console(config-if-vlan10)#exit console(config)#int loopback 0 BGP 1401