Dell N3200-ON Networking N-Series Switches User Guide version 6.8.0 - Page 232

When the failed unit resumes normal operation, the previous configuration that exists for that unit is reapplied by the management unit in the stack. To permanently remove the unit from the stack, enter into Stack Config Mode and use the member command, as the following example shows. console#configure console(config)#stack console(config-stack)#no member 2 console(config-stack)#exit console(config)#exit console#show switch SW Management Standby Status Status 1 Mgmt Sw 3 Stack Mbr 4 Stack Mbr Preconfig Model ID -------N3248X N3248X N3248X Plugged-in Switch Model ID Status N3248X OK N3248X OK N3248X OK Code Version -------6.3.6.4 6.3.6.4 6.3.6.4 Preconfiguring a Stack Member To preconfigure a stack member before connecting the physical unit to the stack, use the show supported switchtype command to obtain the switch model ID (SID) of the unit to be added. The example in this section demonstrates pre-configuring a stand-alone Dell Networking N-Series switch. To configure the switch: 1 View the list of SIDs to determine which SID identifies the switch to preconfigure. The following is the output on the switches. The supported switch types vary by switch series and loaded image. console#show supported switchtype SID Switch Model ID 1 N3248P-ON 2 N3248TE-ON 3 N3224P-ON 4 N3224T-ON 5 N3224F-ON 6 N3224PX-ON 7 N3248PXE-ON 8 N3248X-ON 232 Stacking