Dell OptiPlex 3240 All-in-One Owners Manual - Page 26

Removing the memory module, Removing the intrusion switch, Before Working Inside Your Computer, stand

Get Dell OptiPlex 3240 All-in-One PDF manuals and user guides View all Dell OptiPlex 3240 All-in-One manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

Removing the memory module 1. Follow the procedure in Before Working Inside Your Computer. 2. Remove the: a. stand b. back cover c. system-board shield 3. Pry the retention clips away from the memory module until it pops-up. Lift and remove the memory module from its connector. Installing the memory module 1. Align the notch on the memory-card with the tab in the system-board connector. 2. Press down on the memory module until the release clips spring back to secure them in place. 3. Install the: a. system-board shield b. back cover c. stand 4. Follow the procedure in After Working Inside Your Computer. Removing the intrusion switch 1. Follow the procedure in Before Working Inside Your Computer. 2. Remove the: a. stand b. back cover c. VESA mount bracket d. system-board shield 3. To release the intrusion-switch cable: a. Disconnect the intrusion-switch cable from the connector on the system board [1]. b. Unthread the intrusion-switch cable from the retention clips on the computer [2]. 26

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
Removing the memory module
1.
Follow the procedure in
Before Working Inside Your Computer
.
2.
Remove the:
a.
stand
b.
back cover
c.
system-board shield
3.
Pry the retention clips away from the memory module until it pops-up. Lift and remove the memory
module from its connector.
Installing the memory module
1.
Align the notch on the memory-card with the tab in the system-board connector.
2.
Press down on the memory module until the release clips spring back to secure them in place.
3.
Install the:
a.
system-board shield
b.
back cover
c.
stand
4.
Follow the procedure in
After Working Inside Your Computer
.
Removing the intrusion switch
1.
Follow the procedure in
Before Working Inside Your Computer
.
2.
Remove the:
a.
stand
b.
back cover
c.
VESA mount bracket
d.
system-board shield
3.
To release the intrusion-switch cable:
a.
Disconnect the intrusion-switch cable from the connector on the system board [1].
b.
Unthread the intrusion-switch cable from the retention clips on the computer [2].
26