Dell OptiPlex 7090 Tower Service Manual - Page 18
Removing the 2.5-inch hard-disk drive bracket, Steps, Prerequisites
View all Dell OptiPlex 7090 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Steps 1. Disconnect the power cable and the black hard drive data cable from the connectors on the 2.5-inch hard-disk drive. NOTE: For secondary 2.5-inch hard-disk drive, the other end of the black hard drive data cable is connected to the SATA1 and SATA2 connectors on the system board. 2. Press the release tabs on the hard-disk drive bracket and slide the hard-disk drive assembly out of the hard-disk drive bracket. 3. Lift the hard-disk drive assembly from the computer. NOTE: The orientation of the hard-disk drive so that you can replace it correctly. Removing the 2.5-inch hard-disk drive bracket Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. 3. Remove the 2.5-inch primary hard-disk drive or 2.5-inch secondary hard-disk drive. 18 Removing and installing components