Dell OptiPlex 7090 Tower Service Manual - Page 30
Removing the M.2 2230 PCIe solid-state drive
View all Dell OptiPlex 7090 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Steps 1. Align the notch on the solid-state drive with the tab on the solid-state drive connector. 2. Insert the solid-state drive at a 45-degree angle into the slot on the system board. 3. Replace the screw (M2x3.5) to secure the M.2 2280 solid-state drive to the system board. NOTE: Repeat the above procedure for installing the other solid-state drive. Next steps 1. Install the side cover. 2. Follow the procedure in after working inside your computer. Removing the M.2 2230 PCIe solid-state drive Prerequisites 1. Follow the procedure in before working inside your computer. 2. Remove the side cover. About this task The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure. Steps 1. Remove the screw (M2x3.5) that secures the solid-state drive to the system board. 2. Slide and lift the solid-state drive off the system board. 30 Removing and installing components