Dell OptiPlex 7090 Tower Service Manual - Page 75
M.2 PCIe SSD connector, Internal USB connector
View all Dell OptiPlex 7090 Tower manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
NOTE: Before disconnecting the cables from the system board, note the location of the connectors so that you can reconnect the cables correctly after you replace the system board. 2. Remove the side cover. 3. Remove the front bezel. 4. Remove the memory module. 5. Remove the WLAN. 6. Remove the M.2 2230 SSD/M.2 2280 SSD. 7. Remove the coin-cell battery. 8. Remove the graphics card. 9. Remove the powered GPU. NOTE: This step is required only if the system is configured with powered GPU. 10. Remove the speaker. 11. Remove the intrusion switch. 12. Remove the VR heatsink. 13. Remove the processor fan and 125 W heat-sink assembly or processor fan and heat-sink assembly. 14. Remove the chassis fan. 15. Remove the processor. About this task The following image indicates the connectors on your system board. 1. CPU power connector 2. Processor fan connector 3. Memory module connector 4. Power button connector 5. Remote power switch connector 6. SD card reader connector 7. SATA0 connector (blue) 8. M.2 PCIe SSD connector 9. Internal USB connector Removing and installing components 75